Screen House Room Camping Tent – Installation Manual

📦 What’s Included

• Folding steel frame (pre-assembled)

• Screen tent fabric (with mesh and zipper doors)

• Stakes and ropes

• Carry bag

🛠️ Installation Steps

Step 1: Unfold the Frame

• Take the folded frame out of the bag and stand it upright on level ground.

• Two people grab opposite corners and gently pull outward.

• Expand the frame halfway, keeping it stable.

Step 2: Place the Tent Fabric

• Drape the screen house fabric over the partially expanded frame.

• Align the roof peak and corners.

• Attach the fabric to the top of the frame using Velcro straps.

Step 3: Fully Open the Frame

• Continue pulling out the legs of the frame until fully extended.

• Push the center top hub upward from inside until it clicks into place.

Step 4: Secure the Canopy Fabric

• Fasten all Velcro loops along the trusses and corners to make sure the fabric stays tight.

• Zip up all door panels to keep shape and tension.

Step 5: Adjust the Height

• Press the push buttons on each leg and raise the tent to your preferred height setting.

• Ensure all legs are locked at the same height.

Step 6: Stake and Secure

• Use ground stakes to anchor each leg.

• Tie down the ropes from the corners for added wind resistance.

✅ Helpful Tips

• Always set up with at least 2 people for safety and efficiency.

• Avoid setup on sloped or uneven surfaces.

• Store only when fabric is completely dry to prevent mold or damage.

• Use additional weights if used in windy conditions..